ECRIT Direct Emergency Calling
draft-winterbottom-ecrit-direct-02
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | James Winterbottom , Martin Thomson , Hannes Tschofenig , Henning Schulzrinne | ||
Last updated | 2010-03-07 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The specified IETF emergency services architecture puts a strong emphasis on emergency call and emergency messaging via the Voice Service Provider (VSP) / Application Service Provider (ASP). There are two reasons for this design decision: The call routing via the VSP/ASP is more natural as it follows the standard communication pattern and transition deployments assume non-updated end hosts. As the deployment of the Location-to-Service Translation protocol progresses there are possibilities for upgraded end devices to directly communicate with the IP-based emergency services network without the need to interact with a VSP/ASP, which simplifies the task of regulators as the involved parties are within the same jurisdiction. This memo describes the procedures and operations of a generic emergency calling client utilizing the available building blocks.
Authors
James Winterbottom
Martin Thomson
Hannes Tschofenig
Henning Schulzrinne
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)