A simple wrapper around gstreamer for creating a reliable low-latency Studio Transmitter Link.

stld tx \
	--host 10.32.100.1 \
	--port 3600 \
	[--redundancy 0-2]
	--source 'alsasrc device="hw:0"'	(using ALSA)
	--source 'jackaudiosrc connect=1'	(using JACK)
	--source 'custom gstreamer string'

stld rx \
	--host 0.0.0.0 \
	--port 3600 \
	--sink 'alsasink device="plughw:0"'

Note the host parameter is the address to bind on. STLd provides no authentication. It is recommended to use a firewall to only accept UDP traffic from a known host, or - for example over the internet - to pair with a lightweight point-to-point VPN such as ZeroTier One.

This software is used in production at Insanity Radio.

We wrote this software to replace a faulty pair of Barix/Sonifex streaming boxes.

Other software (such as our alumnus James Harrison's OpenOB) is brilliant and serves as inspiration for this project. However, OpenOB only supports error correction for OPUS/CELT codecs. STLd out-of-the-box uses Redundant RTP coding (audio/red) to improve reliability via the internet (or other networks which may experience a small level of packet loss).

Note: JackD doesn't play nice inside Docker. ALSA works but requires the container to be launched with privileges.

docker build . -t insanityradio/stld:latest
docker run --name stl --restart=always --device /dev/snd --net host --privileged -d insanityradio/stld:latest tx --host 10.0.0.10 --port 3600 --source "alsasrc device=plughw:0" --redundancy 2
docker run --name stl --restart=always --device /dev/snd --net host --privileged -d insanityradio/stld:latest rx --host 0.0.0.0 --port 3600 --sink 'alsasink device="plughw:0"'

For 24/7 broadcast use, you would want to synchronise the sender and receiver clocks. Unfortunately, GStreamer does not provide a mechanism to do this transparently. Hence, if you use STLd with ALSA or Jack, you may experience the occasional drop-out.

For real world use, the PipeWire project provides DLL-based clock synchronisation - a similar technique used in higher end AD/DA. For example, Insanity Radio uses STLd with PipeWire src/sink elements to avoid noticable drops/under-runs on air.

This project requires gstreamer-1.0 with the good and bad plugins installed. Rather than using gstreamer native bindings, this application directly invokes gst-launch-1.0 with a suitable scheduling priority.